Can't install VestaCP - when I use "y" for saying to continue it says goodbye?
Posted: Sat Apr 14, 2018 6:18 pm
I've installed VestaCP many times and this is my first problem with an installation. My VPS is on CentoS 6.5. I generated my installation command from the VestaCP installation page like I always do and followed the steps on the installation page.
After I enter the installation command it starts loading up to the point of where it lists what it is going to load and then asks whether it can continue (y/n). I then type "y" and enter - and then it says "goodbye".
After I enter the installation command it starts loading up to the point of where it lists what it is going to load and then asks whether it can continue (y/n). I then type "y" and enter - and then it says "goodbye".