Page 2 of 2

Re: [v1.0] ioTheme - new theme for VestaCP

Posted: Fri May 29, 2020 11:30 am
by iotheme
xysites wrote: Fri May 29, 2020 10:14 am Would it work with MyVesta fork from dpeca?
You can try with MyVesta, I think it will be ok. (note: Hestia may be not because it has been edited frontend)

Re: [v1.0] ioTheme - new theme for VestaCP

Posted: Sat May 30, 2020 1:50 pm
by dpeca
xysites wrote: Fri May 29, 2020 10:14 am Would it work with MyVesta fork from dpeca?
Works.
Just my span element (with version number and build date) is little wrong positioned :D
Except that element, I actually didn't modified Vesta frontend at all.

Re: [v1.0] ioTheme - new theme for VestaCP

Posted: Tue Jun 02, 2020 11:42 pm
by iotheme
dpeca wrote: Sat May 30, 2020 1:50 pm
xysites wrote: Fri May 29, 2020 10:14 am Would it work with MyVesta fork from dpeca?
Works.
Just my span element (with version number and build date) is little wrong positioned :D
Except that element, I actually didn't modified Vesta frontend at all.
Thanks for confirming. If want, you can integrate it into your fork, I will support it.

Re: [v1.0] ioTheme - new theme for VestaCP

Posted: Wed Jun 03, 2020 7:27 am
by dpeca
iotheme wrote: Tue Jun 02, 2020 11:42 pm Thanks for confirming. If want, you can integrate it into your fork, I will support it.
Thanks :)
I was thinked about it, but then you said "you dont want forks to use this theme", if I understood you well?

Main problem that I saw is that left menu can go below the visible area, without ability to scroll it down, because position is fixed.

Re: [v1.0] ioTheme - new theme for VestaCP

Posted: Wed Jun 03, 2020 12:41 pm
by iotheme
dpeca wrote: Wed Jun 03, 2020 7:27 am
iotheme wrote: Tue Jun 02, 2020 11:42 pm Thanks for confirming. If want, you can integrate it into your fork, I will support it.
Thanks :)
I was thinked about it, but then you said "you dont want forks to use this theme", if I understood you well?

Main problem that I saw is that left menu can go below the visible area, without ability to scroll it down, because position is fixed.
I usually use it with mouse wheel. Whatever fixed it as your feedback, you can try it again. :D